L2Vpn Statistics Interval - H3C MSR 810 Command Reference Manual

Syntax
l2vpn rewrite inbound tag { nest { c-vid vlan-id | s-vid vlan-id [ c-vid
vlan-id ] } | remark 1-to-2 s-vid vlan-id c-vid vlan-id } [ symmetric ]
undo l2vpn rewrite inbound
Default
VLAN tags of incoming traffic are not processed.
Views
Layer 3 aggregate interface view
Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
: Adds VLAN tags.
nest
: Specifies an inner VLAN tag.
c-vid
: Specifies an outer VLAN tag.
s-vid
: Specifies a VLAN ID in the range of 1 to 4094.
vlan-id
: Maps VLAN tags.
remark
: Performs one-to-two mapping to replace the VLAN tag of single tagged packets with the
1-to-2
specified outer and inner VLAN tags.
symmetric
this keyword, VLAN tags of outgoing traffic are not processed.
Usage guidelines
To modify the VLAN tag processing rule for incoming traffic, first execute the
rewrite inbound
command.
inbound
When you use this command, follow these restrictions:
•
The
l2vpn rewrite inbound tag nest s-vid vlan-id c-vid vlan-id
takes effect only on untagged packets.
•
The
l2vpn rewrite inbound tag remark 1-to-2
tagged packets.
Examples
# Configure Layer 3 Ethernet interface GigabitEthernet 1/0/1 to add outer VLAN tag 100 to incoming
frames and remove outer VLAN tag 100 from outgoing frames.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] l2vpn rewrite inbound tag nest s-vid 100 symmetric

l2vpn statistics interval

Use
l2vpn statistics interval
Use
undo l2vpn statistics interval
: Applies the reverse VLAN tag processing rule to outgoing traffic. If you do not specify
command to remove the existing rule, and then execute the
command takes effect only on single
to set the VXLAN statistics collection interval.
to restore the default.
15
undo l2vpn
l2vpn rewrite
command