Ike Sa Nat-Keepalive-Timer Interval; Interval-Time - H3C MSR 20-20 Command Reference Manual

2166 C 141: IKE C
HAPTER
Related command:
Example

ike sa nat-keepalive-timer interval

Syntax
View
Parameter
Description
Example

interval-time

Syntax
View
Parameter
C
ONFIGURATION OMMANDS
By default, no keepalive packet is sent.
Note that the keepalive timeout configured at the local end must be longer than
the keepalive interval configured at the remote end. Since it seldom occurs that
more than three consecutive packets are lost on a network, the keepalive timeout
can be configured to be three times of the keepalive interval.
ike sa keepalive-timer interval.
# Set the keepalive timeout to 20 seconds.
<Sysname> system-view
[Sysname] ike sa keepalive-timer timeout 20
ike sa nat-keepalive-timer interval seconds
undo ike sa nat-keepalive-timer interval
System view
seconds: NAT keepalive interval in seconds, in the range 5 to 300.
Use the
ike sa nat-keepalive-timer interval
keepalive interval.
Use the
undo ike sa nat-keepalive-timer interval
function.
By default, no NAT keepalive packet is sent.
# Set the NAT keepalive interval to 5 seconds.
<Sysname> system-view
[Sysname] ike sa nat-keepalive-timer interval 5
interval-time interval-time
undo interval-time
IKE DPD view
interval-time: Interval in seconds at which DPD query is triggered if no IPSec packet
is received from the peer, in the range 1 to 300.
command to set the NAT
command to disable the