Display Vrrp - H3C MSR 20-20 Command Reference Manual

146

display vrrp

Syntax
View
Parameter
Description
Example
IP 4-B
V
C
OMMANDS
n
The interfaces that VRRP involves can only be Layer 3 Ethernet interfaces and
VLAN interfaces unless otherwise specified.
display vrrp [ verbose ] [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Any view
verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the
specified interface. interface-type interface-number specifies an interface by its
type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to
255.
Use the
display vrrp
If you do not specify verbose, only the brief state information of VRRP is
displayed.
If you specify both interface and standby group, only the state information of the
specified standby group is displayed; if you only specify an interface, the state
information of all the standby groups on the interface is displayed; if you specify
neither, the state information of all the standby groups on the device is displayed.
# Display brief information about all standby groups on the device before a virtual
VRRP standby group is created.
<Sysname> display vrrp
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
The total number of the virtual outers: 1
Interface
---------------------------------------------------------------------
Eth1/0
# Display detailed information about all standby groups on the device.
VRRP C
ASED
command to display the state information of VRRP.
: VIRTUAL-MAC
VRID State
1 Master
ONFIGURATION
Run Adver. Auth
Pri Time Type
100 1 NONE
Virtual
IP
10.10.10.2