Standby Interface - H3C MSR 20-20 Command Reference Manual

2220 C 145: B
HAPTER ACKUP
Description
Related command:
Example

standby interface

Syntax
View
Parameter
Description
C C C
ENTER ONFIGURATION OMMANDS
Use the standby bandwidth
transmission on the main interface.
Use the
undo standby bandwidth
By default, the available bandwidth used for setting the thresholds is 0 kbps.
Note that:
Use this command after backup interfaces are specified.
If the available bandwidth used for setting the thresholds is 0kbps (the default
■
value), the backup center automatically obtains the available bandwidth
provided by the system to set the thresholds. If the backup center fails to
obtain the physical bandwidth, it would prompt you to reconfigure.
If the available bandwidth configured for setting the thresholds exceeds the
■
physical bandwidth on the interface, the load balancing does not take effect.
standby interface
# Configure the available bandwidth used for setting the thresholds on the main
interface Serial 2/0 for load sharing to 10000 kbps.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] standby bandwidth 10000
standby interface interface-type interface-number [ priority ]
undo standby interface interface-type interface-number
Interface view
interface-type interface-number: Specifies an interface by its type and number.
priority: Specifies the priority of the backup interface, in the range 0 to 255. The
greater the value, the higher the priority. The default is 0.
Use the
standby interface
current interface.
Use the
undo standby interface
interface.
By default, no backup interface is specified.
Note that:
This command and the standby interface command cannot be configured at the
same time. That is, if you have configured the standby interface command on
command to configure the bandwidth available for
command to restore the default.
command to specify a backup interface for the
command to remove the specified backup