Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode only receives LLDPDUs.
tx: Specifies the Tx mode. A port in this mode only sends LLDPDUs.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Examples
# Configure the LLDP operating mode as Rx for Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] lldp admin-status rx
lldp check-change-interval
Use lldp check-change-interval to enable LLDP polling and to set the polling interval.
Use undo lldp check-change-interval to restore the default.
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
Default
LLDP polling is disabled.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Parameters
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Examples
# Enable LLDP polling on Ethernet 1/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] lldp check-change-interval 30
lldp enable
Use lldp enable to enable LLDP.
Use undo lldp enable to disable LLDP.
Syntax
lldp enable
undo lldp enable
Default
LLDP is enabled on a port and is globally disabled.
141