Bfd Echo-Source-Ip; Bfd Min-Echo-Receive-Interval - H3C S3610 Series Command Manual

Command Manual – BFD-GR
H3C S3610&S5510 Series Ethernet Switches
[Sysname-Vlan-interface 1] bfd detect-multiplier 6

1.1.3 bfd echo-source-ip

Syntax
bfd echo-source-ip ip-address
undo bfd echo-source-ip
View
System view
Parameters
ip-address: Source IP address of BFD echo packets.
Description
Use the bfd echo-source-ip command to configure the source IP address of BFD
echo packets.
Use the undo bfd echo-source-ip command to remove the configured source IP
address of BFD echo packets.
Note that, since a large amount of ICMP redirect packets may be sent by the remote
device, causing network congestion, do not configure the source IP address of the BFD
echo packets to belong to the same network segment as any interface address of the
device.
Examples
# Configure the source IP address of BFD echo packets as 10.1.1.1.
<Sysname> system-view
[Sysname] bfd echo-source-ip 10.1.1.1

1.1.4 bfd min-echo-receive-interval

Syntax
bfd min-echo-receive-interval value
undo bfd min-echo-receive-interval
View
Interface view
Parameters
value: Minimum BFD echo receiving interval, in milliseconds. This value is in the range
of 200 to 1000 and defaults to 400.
Chapter 1 BFD Configuration Commands
1-3