JunosE 11.2.x Command Reference Guide A to M
ipv6 ospf transmit-delay
Syntax
Release Information
Description
Options
Mode
1082
ipv6 ospf [ processId ] transmit-delay transmDelay
no ipv6 ospf [ processId ] transmit-delay
Command introduced before JunosE Release 7.1.0.
Sets the estimated time it takes to transmit a link-state update packet on the interface.
The no version restores the default value.
processId—Integer in the range 1–65535
transmDelay—Link-state transmit delay, a number in the range 0–3600 seconds;
default value is 1 second
Interface Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.