QoS Policy Commands
show policy classify destination ip
Specifies a destination IP address for a hypothetical packet to show how the QoS software in the switch
will handle the packet.
show policy classify {l2 | l3 | multicast} [applied] destination ip ip_address
Syntax Definitions
l2
l3
multicast
applied
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate policies.
Examples
-> show policy classify l3 destination ip 198.60.22.2
See the output example given on
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The destination IP address.
page 33-167
for more information about the potential screen display.
June 2012
page 33-189