Show Policy Classify Multicast Ip - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

show policy classify multicast ip

Specifies a multicast address for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] multicast ip ip_address
Syntax Definitions
l2
l3
multicast
applied
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate policies.
Examples
-> show policy classify multicast multicast ip 224.22.22.1
Packet headers:
L2:
*Port :
*MAC :
*VLAN :
*802.1p : 0
L3/L4:
*Mcast :
*IP :
*TOS/DSCP : 0/0
Using pending multicast policies
Classify Multicast:
*No rule matched: (accept)
See the output example given on
OmniSwitch CLI Reference Guide
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The multicast IP address (the address of the multicast stream).
0/0 (any)
000000:000000
224.22.22.1
page 33-167 for information about the displayed fields.
June 2012
-> 0/0 (any)
-> 080020:D1E51
0 -> 0
0.0.0.0 -> 0.0.0.0
page 33-191