Show Policy Classify Destination Interface Type - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show policy classify destination interface type

Specifies a destination interface type for a hypothetical packet to show how the QoS software in the switch
will handle the packet.
show policy classify {l2 | l3 | multicast} [applied] destination interface type {ethernet | wan | ethernet-
10 | ethernet-100 | ethernet-1G | ethernet-10G}
Syntax Definitions
l2
l3
multicast
applied
ethernet
wan
ethernet-10
ethernet-100
ethernet-1G
ethernet-10G
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 destination interface type ethernet-10
See the output example given on
Release History
Release 6.1; command was introduced.
page 33-184
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
Indicates that the flow's destination port is an Ethernet interface.
Indicates that the flow's destination port is a WAN interface. Not
supported currently.
Indicates that the flow's destination port is 10 Mb Ethernet.
Indicates that the flow's destination port is 100 Mb Ethernet.
Indicates that the flow's destination port is 1 gigabit Ethernet.
Indicates that the flow's destination port is 10 gigabit Ethernet.
page 33-167 for more information about the potential screen display.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012