Policy Action Port-Disable - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy action port-disable

Administratively disables the source port of the traffic to which this action is applied.
policy action action_name port-disable
policy action action_name no port-disable
Syntax Definitions
action_name
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove port-disable from the policy action.
•
An SNMP trap is sent when a port is administratively disabled through a port disable action or a User-
Ports shutdown function.
•
To enable a port disabled by this action, use the
the port or disconnect and reconnect the port cable.
Examples
-> policy action pd01 port-disable
-> policy action pb02 no port-disable
Release History
Release 6.1.1; command was introduced.
Related Commands
qos apply
show policy action
page 33-158
The name of the action.
interfaces admin
Applies configured QoS and policy settings to the current configuration.
Displays information about policy actions.
QoS Policy Commands
command to administratively enable
OmniSwitch CLI Reference Guide June 2012