Displaying A List Of Rmon Events; Displaying A Specific Rmon Event - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Software release 6
Hide thumbs Also See for OmniSwitch 6850-48:
Table of Contents

Advertisement

Remote Monitoring (RMON)

Displaying a List of RMON Events

RMON Events are actions that occur based on Alarm conditions detected by an RMON probe. To view a
list of logged RMON Events, enter the
for a particular probe, such as:
-> show rmon events
A display showing all logged RMON Events should appear, as shown in the following example:
Entry
Time
---------+----------------+-----------------------------------------------------
1
00:08:00
2
00:26:00
3
00:39:00
The display shown above identifies the Entry number of the specified Event, along with the elapsed time
since the last change in status (measured in hours/minutes/seconds) and a description of the Alarm condi-
tion detected by the probe for all RMON Logged Events. For example, Entry number 3 is linked to ether-
StatsCollisions.2008: [Rising trap] "Rising Event," an Alarm condition detected by the RMON probe in
which a trap was generated based on a Rising Threshold Alarm, with an elapsed time of 39 minutes since
the last change in status.

Displaying a Specific RMON Event

To view information for a specific logged RMON Event, enter the
ing an entry number (event number) for a particular probe, such as:
-> show rmon events 3
A display showing the specific logged RMON Event should appear, as shown in the following example:
Entry
Time
---------+----------------+-----------------------------------------------------
3
00:39:00
The display shown above identifies the Entry number of the specified Event, along with the elapsed time
since the last change in status (measured in hours/minutes/seconds) and a description of the Alarm condi-
tion detected by the probe for the specific RMON Logged Event. For example, Entry number 3 is linked to
etherStatsCollisions.2008: [Rising trap] "Rising Event," an Alarm condition detected by the RMON probe
in which a trap was generated based on a Rising Threshold Alarm, with an elapsed time of 39 minutes
since the last change in status.
page 45-40
show rmon events
Description
etherStatsPkts.4008: [Falling trap] "Falling Event"
etherStatsCollisions.2008: "Rising Event"
etherStatsCollisions.2008: "Rising Event"
Description
etherStatsCollisions.2008: "Rising Event"
OmniSwitch AOS Release 6 Network Configuration Guide
Diagnosing Switch Problems
command without specifying an entry number
show rmon events
command, specify-
September 2009

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents