Policy Action Maximum Depth - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy action maximum depth

Configures the maximum queue depth assigned to this action, in bytes. The queue depth determines the
amount of buffer allocated to each queue. When the queue depth is reached, the switch starts dropping
packets.
policy action action_name maximum depth bytes
policy action action_name no maximum depth
Syntax Definitions
action_name
bytes
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a maximum depth value from a policy action.
•
Note that the bandwidth may be entered in bytes. Alternatively, the bandwidth may be entered in
abbreviated units (1k, 2k, etc). If the bandwidth value is entered in bytes, the switch rounds the value
to the nearest thousand bytes. For example, if you enter 1 to 1024, the result is 1K. If you enter 1025 to
2048, the result is 2K.
Examples
-> policy action action2 maximum depth 100
-> policy action action2 no maximum depth
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the action.
The maximum queue depth, in bytes. The value may be entered as an
integer (for example, 10000) or with abbreviated units (for example,
10k). If the value is entered in bytes, the switch rounds the value up to
the nearest thousand.
June 2012 page 33-143