Policy Action Tos - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy action tos

Configures a Type of Service (ToS) bits value to be applied to packets in outgoing flows to which the
specified policy applies.
policy action action_name tos tos_value
policy action action_name no tos
Syntax Definitions
action_name
tos_value
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a ToS value from a policy action.
•
Note that specifying both ToS and DSCP in the same action is not allowed.
Examples
-> policy action action3 tos 4
-> policy action action3 no tos
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
page 33-148
The name of the action.
The three-bit priority value in the IP header that should be set on outgo-
ing frames in flows that match the specified policy. Values range from 0
(lowest priority) to 7 (highest priority).
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012