Policy Action Priority - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy action priority

Configures the priority for queuing a flow to which the QoS action applies.
policy action action_name priority priority_value
policy action action_name no priority
Syntax Definitions
action_name
priority_value
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a priority value from an action.
•
This priority value is independent of 802.1Q, Type of Service (ToS), or Differentiated Services Code
Point (DSCP) values.
•
Note that the value displayed on the
here.
Examples
-> policy action action1 priority 1
-> policy action action1 no priority
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
OmniSwitch CLI Reference Guide
The name of the action.
The priority given to scheduling traffic on the output port. Values range
from 0 (lowest) to 7 (highest).
show qos queue
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
June 2012
screen may be different from the value entered
page 33-139