Show Policy Classify - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

show policy classify

Sends hypothetical information to the Layer 2, Layer 3, or multicast classifier to see how the switch will
handle the packet. Used to verify that a policy rule works a particular way.
This section describes the base command. Optional keywords are listed below and described as separate
commands later in this chapter. (Note that options may be used in combination but are described sepa-
rately for ease in explanation.)
show policy classify {l2 | l3 | multicast} [applied]
[source port slot/port]
[destination port slot/port]
[source mac mac_address]
[destination mac mac_address]
[source vlan vlan_id]
[destination vlan vlan_id]
[source interface type {ethernet | wan | ethernet-10 | ethernet-100 | ethernet-1G | ethernet-10G}]
[destination interface type {ethernet | wan | ethernet-10 | ethernet-100 | ethernet-1G | ethernet-
10G}]
[802.1p value]
[source ip ip_address]
[destination ip ip_address]
[multicast ip ip_address]
[tos tos_value]
[dscp dscp_value]
[ip protocol protocol]
[source ip port port]
[destination ip port port]
Syntax Definitions
l2
l3
multicast
applied
Defaults
By default, only pending policies are examined.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
OmniSwitch CLI Reference Guide
Uses the Layer 2 classifier for the hypothetical packet. Typically speci-
fied for port, MAC address, VLAN, interface type, or 802.1p.
Uses the Layer 3 classifier for the hypothetical packet. Typically speci-
fied for interface type, IP address, ToS or DSCP, IP protocol, or TCP/
UDP port.
Uses the multicast IGMP classifier for the hypothetical packet. Typi-
cally specified for multicast IP address (which is the multicast stream)
and destination parameters (for the client issuing an IGMP request).
Indicates that only applied policies should be examined.
June 2012 page 33-167