Policy Action 802.1P - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy action 802.1p

Configures a value to be set in the 802.1p bits of the 802.1Q byte of an outgoing frame for traffic that
matches a policy with this action.
policy action action_name 802.1p 802.1p_value
policy action action_name no 802.1p
Syntax Definitions
action_name
802.1p_value
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove an 802.1p value from a policy action.
•
Note that specifying both ToS and DSCP in the same action is not allowed.
Examples
-> policy action action4 802.1p 7
-> policy action action4 no 802.1p
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
page 33-150
The name of the action.
The priority value to be set in 802.1Q frames. Values range from 0
(lowest priority) to 7 (highest priority).
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012