Show Policy Classify Source Vlan - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show policy classify source vlan

Specifies a source VLAN for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] source vlan vlan_id
Syntax Definitions
l2
l3
multicast
applied
vlan_id
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 source vlan 2
See the output example given on
Release History
Release 6.1; command was introduced.
page 33-178
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The destination VLAN ID for the flow.
page 33-167 for more information about the potential screen display.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012