Policy Condition Destination Mac Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition destination mac group

Associates a destination MAC group with a policy condition.
policy condition condition_name destination mac group mac_group
policy condition condition_name no destination mac group
Syntax Definitions
condition_name
mac_group
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a destination MAC group from a policy condition;
however, at least one classification parameter must be associated with a condition.
•
A destination MAC address and a destination MAC group cannot be specified in the same condition.
Examples
-> policy condition cond5 destination mac group mac_group1
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy mac group
policy condition
show policy condition
page 33-106
The name of the condition. May be an existing condition name or a new
condition.
The name of the destination MAC group, configured through the policy
mac group command. See
command.
Applies configured QoS and policy settings to the current configuration.
Configures a MAC group and its associated MAC addresses.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
page 33-21 for more information about this
OmniSwitch CLI Reference Guide June 2012