Show Port-Security - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show port-security

show port-security
Displays Learned Port Security (LPS) configuration and table entries.
show port-security {port [slot/port[-port2] | slot slot]}
Syntax Definitions
slot/port
-port2
slot
Defaults
By default, all ports with an LPS configuration are displayed.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Displays ports that have an LPS configuration, even if LPS is disabled on the port.
•
Use the port parameter and the port numbers with this command to display the LPS configuration for a
specific port or a range of ports.
•
Use the slot parameter and the slot numbers with this command to display the LPS configuration for all
the ports on a specific slot.
•
In addition, MAC addresses learned on the LPS enabled port that are within the specified MAC address
range, appear as a separate entries in the LPS table as dynamic MAC type addresses.
•
Dynamic MAC addresses are stored as configured MAC addresses in the LPS table when the switch
configuration is saved and the switch is rebooted. If the configuration is not saved before the next
reboot, all dynamic MAC addresses are cleared from the LPS table.
•
The MAC TYPE field is blank if an authorized MAC address range is configured for the LPS enabled
port.
page 30-14
The slot number for the module and the physical port number on that
module (for example, 3/1 specifies port 1 on slot 3).
The last port number in a range of ports you want to configure on the
same slot (for example, 3/1-4 specifies ports 1-4 on slot 3).
Enter the slot number for a module to specify that the command should
include all ports on that module (for example, 6 specifies all ports on the
module found in slot 6 of the switch chassis).
Learned Port Security Commands
OmniSwitch CLI Reference Guide March 2011