Policy Condition Source Port Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition source port group

Associates a source port group with a policy condition. Use the no form of the command to remove a
source port group from a condition.
policy condition condition_name source port group group_name
policy condition condition_name no source port group
Syntax Definitions
condition_name
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use the no form of the command to remove a source port group from a condition; however, at least one
classification parameter must be associated with a condition.
Examples
-> policy condition cond6 source port group portgr4
Release History
Release 6.1; command was introduced.
Related Commands
policy port group
qos apply
policy condition
show policy condition
page 33-126
The name of the condition. May be an existing condition name or a new
condition.
The name of the source port group. Port groups are configured through
the policy port group command. See
about this command.
Configures a port group and its associated slot and port numbers.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
page 33-23 for more information
OmniSwitch CLI Reference Guide June 2012