Policy Condition Dscp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition dscp

Configures the Differentiated Services Code Point (DSCP) for a policy condition. The DSCP value defines
the six most significant bits of the DS byte in the IP header.
policy condition condition_name dscp {dscp_value[-value]} [mask dscp_mask]
policy condition condition_name no dscp
Syntax Definitions
condition_name
{dscp_value[-value]}
dscp_mask
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a DSCP value from a condition; however, at least one
classification parameter must be associated with a condition.
•
If a DSCP value is specified, a ToS value may not be specified.
Examples
-> policy condition cond4 dscp 10
-> policy condition cond5 dscp 20-30
Release History
Release 6.1; command was introduced.
Release 6.3.1; support for specifying a DSCP range of values without a mask added for OS6850.
page 33-98
The name of the condition. May be an existing condition name or a new
condition.
The DiffServ Code Point value, in the range 0–63. Use a hyphen to
specify a range of DSCP values for the condition (for example, 10-20).
The mask for the DiffServ Code Point, in the range 0–63.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012