Policy Condition Destination Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition destination port

Configures a destination port number for a policy condition.
policy condition condition_name destination port slot/port[-port]
policy condition condition_name no destination port
Syntax Definitions
condition_name
slot/port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of the command to remove a destination port from a condition; however, at least one
classification parameter must be associated with a condition.
•
The destination port condition only applies to bridged traffic on the OmniSwitch 6400, 6850, and 6855.
However, this condition is applied to both bridged and routed traffic on the OmniSwitch 6850E,
6855-U24X, and 9000E.
Examples
-> policy condition cond3 destination port 4/2
-> policy condition cond4 destination port 4/3-4
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
page 33-124
The name of the condition. May be an existing condition name or a new
condition.
The slot and port number (or range of ports) on which the frame is
received.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012