Policy Condition Inner 802.1P - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition inner 802.1p

Configures an inner (customer) source 802.1p value for a policy condition. This condition applies to
double-tagged VLAN Stacking traffic and is used to classify such traffic based on the inner 802.1p bit
value.
policy condition condition_name inner 802.1p 802.1p_value[-802.1p_value]
policy condition condition_name no inner 802.1p
Syntax Definitions
condition_name
802.1p_value[-802.1p_value]
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Rather than creating several policy conditions for contiguous inner 802.1p values, it is possible to spec-
ify a range of values with this command to apply multiple 802.1p values with one condition.
•
Use the no form of the command to remove an inner 802.1p value, or range of values, for a condition;
however, at least one classification parameter must be associated with a condition.
•
When a range of values is configured for a single condition, removing a single value from within that
range is not allowed. All 802.1p values are removed from a condition when the no form of this
command is used.
•
Policies that use the inner 802.1p condition are referred to as QoS VLAN Stacking policies. These are
separate policies from those configured through the VLAN Stacking Service application.
•
Use the source 802.1p policy condition to classify double-tagged traffic based on the 802.1p value of
the outer VLAN tag of the packet.
•
Note that if the Quarantine Manager Remediation (QMR) feature is active on the switch, configuring
VLAN Stacking services and inner VLAN or 802.1p policies is not available. QMR is considered
active when there are MAC addresses present in the Quarantine MAC group.
Examples
-> policy condition cond1 inner 802.1p 0-7
-> policy condition cond2 inner 802.1p 5
page 33-120
The name of the condition. May be an existing condition name or a new
condition.
The 802.1p value, or range of values, to match on the inner 802.1Q
VLAN tag of double-tagged packets. Use a hyphen to specify a range of
values (e.g., 2-5). Only one entry is allowed per command line (a single
802.1p value or a range of values, not both). Valid 802.1p values range
from 0 (lowest priority) to 7 (highest priority).
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012