Learned Port Security Commands
show port-security shutdown
Displays the amount of time during which source learning can occur on all LPS ports.
show port-security shutdown
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
The source learning time limit is a switch-wide parameter that applies to all ports that have LPS
enabled.
•
If the shutdown time is set to zero, then a source learning time limit is not active on LPS ports.
•
Note that source learning of configured authorized MAC addresses is still allowed after the LPS time
limit has expired; however, all learning is stopped if the number of MAC addresses learned meets or
exceeds the maximum number of addresses allowed, even if the LPS time limit has not expired.
Examples
-> show port-security shutdown
LPS Shutdown Config
Convert-to-static
Remaining Learning Window
output definitions
LPS Shutdown Config
Convert-to-static
Remaining Learning Window The remaining amount of time during which the LPS port can learn
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
= 2 min
= DISABLE
= 110 sec
The configured amount of time during which the LPS port can learn
new MAC addresses.
Indicates whether or not dynamic MACs are converted to static MACs
(enabled or disabled). Configured through the
port-security shutdown
MAC addresses.
November 2009
command.
page 19-23