Policy Condition Destination Vlan - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition destination vlan

Configures a destination VLAN (multicast only) for a policy condition. Use the no form of the command
to remove a destination VLAN from a condition.
policy condition condition_name destination vlan vlan_id
policy condition condition_name no destination vlan
Syntax Definitions
condition_name
vlan_id
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a destination VLAN from a condition; however, at least
one classification parameter must be associated with a condition.
•
Note that this condition is supported for multicast only policies.
Examples
-> policy condition cond4 destination vlan 3
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
page 33-116
The name of the condition. May be an existing condition name or a new
condition.
The destination VLAN ID for the flow.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012