Policy Condition Source Vlan Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition source vlan group

Associates a source VLAN group with a policy condition.
policy condition condition_name source vlan group vlan_group
policy condition condition_name no source vlan group
Syntax Definitions
condition_name
vlan_group
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a source VLAN group from a policy condition; however,
at least one classification parameter must be associated with a condition.
•
The source vlan group condition classifies double-tagged traffic (for example, VLAN Stacking pack-
ets) based on the value of the outer VLAN tag of the packet. Use the inner source vlan group condi-
tion to classify double-tagged traffic based on the value of the inner VLAN tag of the packet.
•
A source VLAN ID and a source VLAN group cannot be specified in the same condition. However, a
source VLAN ID or group and an inner source VLAN ID or group can be specified in the same condi-
tion.
Examples
-> policy condition cond1 source vlan group vlan_group1
-> policy condition cond2 source vlan group vstack1 inner source vlan 150
-> policy condition cond3 source vlan group vstack1 inner source vlan group invlan1
-> policy condition cond1 no source vlan group
Release History
Release 6.4.3; command was introduced.
page 33-110
The name of the condition. May be an existing condition name or a new
condition.
The name of an existing VLAN group, configured through the policy
vlan group command. See
command.
QoS Policy Commands
page 33-25 for more information about this
OmniSwitch CLI Reference Guide June 2012