Policy Condition Source Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition source port

Configures a source port number for a policy condition. Use the no form of the command to remove a
source port number from a condition.
policy condition condition_name source port slot/port[-port]
policy condition condition_name no source port
Syntax Definitions
condition_name
slot/port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use the no form of the command to remove a source port from a condition; however, at least one classifi-
cation parameter must be associated with a condition.
Examples
-> policy condition cond2 source port 3/1
-> policy condition cond3 source port 3/2-4
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
page 33-122
The name of the condition. May be an existing condition name or a new
condition.
The slot and port number (or range of ports) on which the frame is
received.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012