Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2300

•
Note that even though tcpflags can be used with most action parameters, it is mainly intended for ACL
use.
Examples
-> policy condition c1 tcpflags all f s mask f s a
-> policy condition c2 tcpflags any a r mask a r
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
MIB Objects
alaQoSConditionTable
alaQoSConditionTcpFlags,
alaQoSConditionTcpFlagsStatus,
alaQoSConditionTcpFlagsVal,
alaQoSConditionTcpFlagsValStatus,
alaQoSConditionTcpFlagsMask,
alaQoSConditionTcpFlagsMaskStatus,
alaQoSAppliedConditionTable
alaQoSAppliedConditionTcpFlags,
alaQoSAppliedConditionTcpFlagsStatus,
alaQoSAppliedConditionTcpFlagsVal,
alaQoSAppliedConditionTcpFlagsValStatus,
alaQoSAppliedConditionTcpFlagsMask,
alaQoSAppliedConditionTcpFlagsMaskStatus,
page 33-80
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide June 2012