Policy Condition Service - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy condition service

Configures a service for a policy condition.
policy condition condition_name service service_name
policy condition condition_name no service
Syntax Definitions
condition_name
service_name
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a service group from a condition; however, at least one
classification parameter must be associated with a condition.
•
A policy condition that specifies a service cannot also specify a service group, IP protocol, source IP
port, or destination IP port.
Examples
-> policy condition cond12 service serv2
Release History
Release 6.1; command was introduced.
Related Commands
policy service
qos apply
show policy service
MIB Objects
alaQoSConditionTable
alaQoSConditionService
alaQoSAppliedConditionTable
alaQoSAppliedConditionService
OmniSwitch CLI Reference Guide
The name of the condition.
The service name, configured through the policy service command.
Configures a service that may be used as part of a policy service group.
Applies configured global QoS and policy settings to the current config-
uration (changes will be active and stored in flash).
Displays information about all particular policy services or a particular
policy service configured on the switch.
June 2012 page 33-81