Port-Security Max-Filtering - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

port-security max-filtering

Configures the maximum number of MAC addresses that can be filtered on the LPS port(s).
port-security slot/port[-port2] max-filtering number
Syntax Definitions
slot/port
-port2
number
Defaults
By default, the maximum number of filtered MAC addresses that can be learned on an LPS port is set to 5.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
When the number of filtered MAC addresses learned on the port reaches the maximum, either the port is
disabled (Shutdown Violation mode) or MAC address learning is disabled (Restrict Violation mode). By
default, MAC address learning is disabled.
Examples
-> port-security 1/10 max-filtering 6
-> port-security 1/10-13 max-filtering 18
Release History
Release 6.6.1; command was introduced.
Related Commands
port-security maximum
port-security violation
MIB Objects
learnedPortSecurityTable
lpsMaxFilteredMacNum
page 19-8
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
The maximum number of filtered MAC addresses (1–100) that are
allowed on this port.
Specifies the maximum number of source MAC addresses that an LPS
port(s) is allowed to learn.
Selects the method for handling traffic that does not comply with LPS
restrictions for the specified port.
OmniSwitch 6250 CLI Reference Guide
Learned Port Security Commands
November 2009