Policy Condition Service Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

policy condition service group

Associates a policy service group with a policy condition.
policy condition condition_name service group service_group
policy condition condition_name no service group
Syntax Definitions
condition_name
service_group
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a service group from a condition; however, at least one
classification parameter must be associated with a condition.
•
A policy condition that specifies a service group cannot also specify a service, IP protocol, source IP
port, or destination IP port.
Examples
-> policy condition cond12 service group servgroup2
Release History
Release 6.1; command was introduced.
Related Commands
policy service group
policy condition
qos apply
show policy condition
page 33-82
The name of the condition.
The service group name. Service groups are configured through the
policy service group command. See
about this command.
Configures a service group and its associated services.
Creates a policy condition.
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
page 33-19 for more information
OmniSwitch CLI Reference Guide June 2012