Procedure 10-15: Optical Port Provisioning For Sc; Procedure 10-16: Dcc Provisioning For Sc; Cit O; Overview ....................................................................................................................................................................................... 1-1 - Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual

Network establishment and testing
...................................................................................................................................................................................................................................
Prerequisites
Make sure all assumptions listed below are fulfilled before carrying out any O
procedures:
1. Two Controllers of type CTL/3S and two cross-connection and timing units (XC160,
XC320/B or XC640) are used (duplex control is recommended for O
2. An MC (Management Communication etwork) per management domain has been
set up.
3. The SC topology has been planned.
4. All used optical ports are clean. A cleaning procedure is given in appendix A, section
Procedure A-13: "Fiber cleaning" (p.
5. The maximum overload values of the used optical circuit packs are not exceeded at
the input ports (see chapter 1, section
Where an overload has been detected replace the existing LBO by an appropriate one
(see appendix A, section
Required procedures
The following procedures have to be done to prepare the system for O
1. Procedure 10-14: "Setting the IP address and O
nodes" (p. 10-81)
2. Procedure 10-15: "Optical port provisioning for SC " (p. 10-84)
3. Procedure 10-16: "DCC provisioning for SC " (p. 10-86)
4. Procedure 10-17: "Launching the WaveStar
time" (p.
Contents
Procedure 10-14: Setting the IP address and O
SC nodes

Procedure 10-15: Optical port provisioning for SC

Procedure 10-16: DCC provisioning for SC

Procedure 10-17: Launching the WaveStar
time
...................................................................................................................................................................................................................................
10-80
Procedure A-14: "Replacing LC-type LBOs" (p.
10-88).
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
A-24).
"Optical circuit pack specifications" (p.
S system parameters of the SC
®

CIT O

S application for the first
S system parameters of the
®
CIT O S application for the first
ONNS provisioning
Overview
S
S).
1-14)).
A-27)).
S:
10-81
10-84
10-86
10-88
365-374-198R10.5.4
Issue 1 July 2009