Setting Startup Conditions - Omron F250-UME Software Manual

Setting Startup Conditions

5-7 Setting Startup Conditions
Note *The asterisk (*) indicates the default setting.
SeeAlso
Use the following procedure to set the status when the power is turned ON. If
the Controller is set to start in Run Mode for the scene where the desired mea-
surement conditions are registered, measurement of objects can be started by
simply turning the power ON.
Also, unnecessary menu selection screens and Camera setting screens that
are always displayed at startup can be set to not be displayed.
Item
Startup scene Selections: 0* to 31
group
When a scene group between 1 and 31 is selected, make sure
the Memory Card where that scene group is stored is inserted.
Startup scene Selections: 0* to 31, OFF(scene number when saved to flash
memory)
Startup mode Selections: Set, Monitor*, Run, OFF(mode when saved to flash
memory)
Startup language Select the language for screen messages.
Selections: Japanese, English*
Camera settings at Select whether or not to display the Camera Settings Screen.
startup
Selections: ON* (display), OFF (no display)
1. Enter System mode and select Startup mode.
Refer to
The Startup Mode Settings Screen will be displayed.
Startup mode
2. Change the settings.
3. Select End.
The settings will be saved and the System Mode Screen will return.
Details
.
Startup Scn Group :
Scn Group 0
Startup scene :
Scn 0
Startup mode :
MON
Language :
English
Camera settings :
End
Section 5-7
ON
5-(33)