Omron F250-UME Software Manual page 380

EC Defect
2-15-6 Setting the Coordinate Mode
Coordinate mode
Output coordinate:
After scroll
Calibration
End
The asterisk (*) indicates the default setting.
CHECK
2-15-(47)
Select the type of coordinate values.
Before scroll:Output made using the coordinate values
After scroll*:Output made using the coordinate values
Refer to
output coordinates.
: OFF
ON:
OFF*: Output made using Camera coordinate values.
If the coordinate mode is changed after the judgement conditions have been
set, the measurement results will change also. Change the judgement condi-
tions to enable correct measurement.
1. Select Coordinate mode.
1.EC defect
The Coordinate Mode Settings Screen will be displayed.
Coordinate mode
2. Make the settings for each item.
3. Select End.
The settings will be registered and the screen in (1.) will return.
before position displacement compensation.
after position displacement compensation.
for differences between
Output made using coordinate values set using calibration.
Measurement image
Extract edges
Removal regions
Removal image
Inspected regions
Coordinate mode
Output coordinate:
After scroll
Calibration : OFF
End
Section 2-15