Omron F250-UME Software Manual page 124

Binary Position Compensation
CHECK
CHECK
STEP 2: Using the Fill Profile Function (Setting Judgement Conditions)
2-5-(5)
4. Move the cursor to the upper limit and use the Left and Right Keys to
change the value.
Right Key:
SHIFT+Right Keys: Increases the value 10 times faster.
Left Key:
SHIFT+Left Keys:
Up and Down Keys: Switches between setting items.
5. Use the same method to change the lower value.
Set the upper and lower limits to make the measurement object white.
6. Select OK.
The settings will be registered and the screen in (2.) will return.
It is also possible to set the binary level so that measurement is performed
only for an intermediate density range.
The fill profile function is set when the exterior of the measurement object is
being measured.
Turn ON the fill profile function to measure the whole area between the start
point (black pixels to white) and the end point (white pixels to black) in the
measurement region as white pixels. The default setting for this function is
OFF.
This area will be measured as white pixels.
Example
Input image
Measurement region
Increases the lowest digit by one.
Decreases the lowest digit by one.
Decreases the value 10 times faster.
Make the measurement object white.
Binary level
Upper[255]
Lower[128]
Reverse
:Move :Change
Measurement region
Start point End point
Fill profile: ON
Section 2-5
Auto
OK