Omron F250-UME Software Manual page 149

EC Position Compensation
The screen for drawing figures will be displayed.
Input figure
3. Specify the center position of the circle.
Up/Down/Left/Right Keys: Move the cursor.
ENT Key:
The screen for setting the radius will be displayed.
Input figure
4. Specify the radius (3 to 512 pixels).
Up/Right Keys: Larger
Down/Left Keys: Smaller
ENT Key: Confirms the setting.
The screen for setting the latitude of the radius will be displayed.
Input figure
5. Specify the latitude the radius (1 to 64 pixels).
Up/Right Keys:
Down/Left Keys: Smaller
ENT Key:
The settings will be registered and the screen in (1.) will return.
Confirms the setting.
Larger
Confirms the setting.
Section 2-6
251,365
100
20
2-6-(11)