Omron F250-UME Software Manual page 282

Detecting Binary Defects
2-12-5 Measurement Screens
SeeAlso
CHECK
Judgement Result
0.Scn 0 RUN
1.Binary defect
Judge: NG
0
Region number
2-12-(39)
Detailed measurement values can be displayed on the screen in Monitor and
Run modes. These values are useful when adjusting measurement conditions.
This section describes what kind of information can be displayed for binary
defect detection.
Refer to
Run modes.
Press the SHIFT+ESC Keys on the Run Screen to access the following screen
and change Display results to Details.
0.Scn 0
Use the Up or Down Key to change to the unit for which binary defect detec-
tion is set and the following detailed screens will be displayed.
Use the SHIFT+Right or Left Keys to switch in order between the four
screens.
NG 45ms
Judgement result for this unit
Inspection region displayed in OK color for OK result and
displayed in NG color for NG result.
(Figures drawn in OR mode are displayed in solid lines and
figures drawn in NOT mode are displayed in dotted lines.)
Center of gravity
RUN
Image status
:
Freeze(Before scroll)
Display image
: Image0
Image size
: All
Display results
: Details
End
Section 2-12
for details on Monitor and