Table of Contents
Advertisement
Density Defects
2-14-3
Setting the Coordinate Mode
Coordinate mode
Output coordinate:
After scroll
Calibration
End
The asterisk (*) indicates the default setting.
CHECK
Select the type of coordinate values.
Before scroll:Output made using the coordinate values
After scroll*:Output made using the coordinate values after
Refer to
output coordinates.
: OFF
ON:
OFF*: Output made using Camera coordinate values.
If the coordinate mode is changed after the judgement conditions have been
set, the measurement results will change also. Change the judgement condi-
tions to enable correct measurement.
1.
Select Density defect.
0.Scn 0=SET=
The settings selections will be displayed.
1.Density defect
2.
Select Coordinate mode.
The Coordinate Mode Settings Screen will be displayed.
3.
Make the settings for each item.
4.
Select End.
The settings will be registered and the screen in (2.) will return.
before position displacement compensation.
position displacement compensation.
for differences between
Output made using coordinate values set using calibration.
0.Camera image
1.Density defect
2.
Measurement image
Select region
Coordinate mode
Output coordinate:
After scroll
Calibration
: OFF
End
Section 2-14
2-14-(33)
Advertisement
Chapters
Table of Contents
