Table of Contents
Advertisement
EC Circle Count
CHECK
4.
Select the desired drawing mode (OR/NOT).
An arrow cursor will appear.
Inspected region
5.
Draw the figure for the inspection region.
The figure will be registered.
6.
If additional figures are to be drawn, select Add.
7.
Repeat steps 3 to 5 as necessary to create the desired shape.
8.
After drawing is completed, select End.
The measurement region will be registered and the screen in (1.) will re-
turn.
Figures drawn in OR mode are displayed in solid lines. Figures drawn in
NOT mode are displayed in dotted lines.
Up to three figures (0, 1, and 2)
can be drawn.
Once three figures have been drawn,
Add will no longer be displayed.
Inspected region
Add
Figure0
End
Figure 1 (drawn using OR)
Figure 2 (drawn using NOT)
Figure 3 (drawn using OR)
Section 2-19
[0]
492,405
2-19-(8)
Advertisement
Chapters
Table of Contents
