Omron F250-UME Software Manual page 381

EC Defect
2-15-7 Measurement Screens
SeeAlso
CHECK
Judgement Result
Defect Area
Detailed measurement values can be displayed on the screen in Monitor and
Run modes. These values are useful when adjusting measurement conditions.
This section describes what kind of information can be displayed for EC defect
inspections.
Refer to
Run modes.
Press the SHIFT+ESC Keys on the Run Screen to access the following screen
and change Display results to Details.
0.Scn 0
Press the Up or Down Key to change to the unit for which EC defect inspec-
tion is set and the following detailed screens will be displayed.
Press the SHIFT+Right or Left Keys to switch in order between the five
screens.
0.Scn 0 RUN
1.EC defect
0
Judge:NG
Region number
A list of the area of defects will be displayed for each region.
0.Scn 0 RUN
1.EC defect
Area
0. 105.123
1.
2.
3.
4.
5.
6.
7.
RUN
Image status
:
Freeze(Before scroll)
Display image
: Image0
Image size
: All
Display results
: Details
End
NG 45ms
Judgement result for this unit
Inspection region displayed in OK color
for OK result and displayed in NG color
for NG result.
(Figures drawn in OR mode are
displayed in solid lines and figures
drawn in NOT mode are displayed in
dotted lines.)
NG 45ms
NG regions will be highlighted.
Region number
Section 2-15
for details on Monitor and
2-15-(48)