Omron F250-UME Software Manual page 349

EC Defect
STEP 4: Setting the Radius of the Circle
If Clear is selected, the selected figure will be cleared.
Set the radius and the permissible radius range for the circle to be removed.
If the circle search is set to OFF, the center of the circle will be the position
specified here.
1. Select Radius.
Removal region0(Circle)
The Input Figure Screen will be displayed.
Input figure
2. Specify the center of the circle.
Up/Down/Left/Right Keys:
ENT Key:
The Radius Settings Screen will be displayed.
Input figure
3. Set the radius of the circle.
Up/Right Keys:
Down/Left Keys: Decrease the radius.
ENT Key:
Circle color
Search conditions
Removal region
Radius
Latitude of angle
Clear
Move the cursor.
Confirms the setting.
Increase the radius.
Confirms the setting.
Section 2-15
251,365
100
2-15-(16)