Table of Contents
Advertisement
QUEST Character Verification
STEP 4: Slender Characters
2-21-(19)
The frame size of the extracted characters is checked during QUEST charac-
ter verification and if the horizontal to vertical aspect ratio is greater than the
set value, the verification will be performed using the "1", "I", "J", ":", and "/" dic-
tionary models only.
If the font itself is slender, characters other than those listed above may be
above the set aspect ratio and verification will not, therefore, be performed cor-
rectly. Set this value, the guide for the aspect ratio, to a higher value for slender
fonts.
/
Height
Width
Example:
2
40
10
1.
Select Slender character.
Character conditions
The Slender Character Settings Screen will be displayed.
Slender character
2.
Set the aspect ratio.
3.
Select End.
The settings will be registered and the screen in (1.) will return.
Aspect ratio (height
40 ÷ 10 = 4
At the default aspect ratio setting of 3.0, the
slender character shown to the left will not be
verified against the "2" in the dictionary model.
Set the aspect ratio to a value higher than 4.
Font
Symbol
Date
K B - 6 5 7 6 2
Slender character
0 1 . 1 1. 0 7
Aspect ratio(Height/Width):
:
[ 3.0]
End
Section 2-21
width)
Advertisement
Chapters
Table of Contents
