Table of Contents
Advertisement
EC Position Compensation
2-6-3-4
Multi-points
STEP 1: Setting Measurement Conditions
Measurement conditions
Note 1
Target color
Specifying angle
Note 2
Range of angle
Limits of angle
Specifying length
Length 1
Note 3
Limits of length 1
Length 2
Note
1
Set mea-
surement
conditions.
Set the conditions for searching for the positioning mark.
:
Black
:
OFF
:
[ 90]
:
[10]
:
OFF
:
[100]
:
[ 80:120]%
:
[ 50]
End
1.
Select whether the positioning mark color will be white or black compared
to the background. (Black*, white)
The asterisk (*) indicates the default setting.
2.
Angles
Use the following settings to set the angle of intersection and thus find the
coordinates of only the desired intersection even though many lines exist
on the screen.
Specifying angle: Set to ON.
Range of angle: Angle of the section in the target color (If the target color
Limits of angle:
Example: To extract the 3
cross points shown in the
following diagram
To find the coordinates of the cross point of lines regardless of their angle,
set Specifying angle to OFF. The settings for the angle will be ignored.
Setting item
Specifying angle ON, OFF*
Range of angle
0 to 359
Limits of angle
0 to 99 (10*)
The asterisk (*) indicates the default setting.
(As required)
2
3
Set condi-
Set search
tions for
region.
obtaining
lines.
Limits of length 2
Note 3
Sorting method
Note 4
Defined side of θ
Note 5
changes, change the angle setting too.)
Set the permissible range for the angle.
Example: When the range of the angle is set to 90 and
the limits of angle set to 10 , the cross point of lines that
intersect at between 80 and 100 will be found.
Selections
Section 2-6
4
Register
reference
position.
:
[ 80:120]%
:
X Ascending order
:
Midline of corner
Set the Target color to black,
the Specifying angle to ON,
and the Range of angle to 60
•
.
60°
2-6-(29)
Advertisement
Chapters
Table of Contents
