Omron F250-UME Software Manual page 318

Density Defects
2-14-(20)
• To measure defects in measurement objects with variable heights
only:
Draw the edge detection region so that the measurement region X co-
ordinates will remain the same for both the left and right edges. The
left and right edges will always have these edge points.
20,100
Left edge region
20,410
The measurement region will adjust to the upper
and lower edges only before measurement is performed.
• To Measure Defects and Burrs in the Upper Section of Measurement
Regions with Variable Widths Only:
Draw the edge detection region so that the measurement region Y co-
ordinates will remain the same for both the upper and lower edges.
The upper and lower edges will always have these edge points.
Note Specify X line under Measurement conditions/measurement direc-
tion.
100, 95
Lower edge region
100, 245
Left edge region
• To Measure Defects and Burrs in the Left Section of Measurement Re-
gions with Variable Heights Only:
Draw the edge detection region so that the measurement region X co-
ordinates will remain the same for both the left and right edges. The
left and right edges will always have these edge points.
Upper edge region
450,100
450,410
Lower edge region
Upper edge region
470, 95
Defect or burr
470, 245
Right edge region
Section 2-14
Right edge region