Omron F250-UME Software Manual page 827

Setting Conditions for Saving Measurement Images
Switching Method
CHECK
In Monitor Mode or Run Mode, press the SHIFT+Up/Down Keys to switch
between images.
Last * (Mem
Last 2 (Mem
Last 1 (Mem
Last (Mem
Image just after measurement
Last 35 (Mem
Last 34 (Mem
• When Display is set to Last NG, the display cannot be switched to stored
images. Change the display to Freeze or another display mode and then
use the SHIFT+Up/Down Keys to switch between images.
• When the image input processing items Camera image or Switch camera
are set to 2 or more units, use the Up and Down Keys to switch between
images.
)
+
SHIFT
)
+
SHIFT
)
+
SHIFT
)
+
SHIFT
The image display status changes
depending on the settings under
+
SHIFT
SYS/Conditions .
If the following conditions hold, the
)
number of stored images will not
+
SHIFT
exceed 34.
)
Section 5-5
Image storage: Set to only NG
Last measurement was OK.
5-(29)