Table of Contents
Advertisement
Detecting Binary Defects
STEP 3: Drawing the Measurement Region
1.
Select Measurement conditions.
Region0(Area(var.box))
The Measurement Conditions Settings Screen will be displayed.
Measurement conditions
2.
Select ON or OFF.
3.
Select End.
The settings will be registered and the screen in (1.) will return.
The measurement region is drawn by specifying the upper, lower, left, and
right edges of the measurement object. If even one of the edges cannot be
located, the judgement result will be NG.
Left edge
When one of the edges is selected, the settings for the conditions for the
selected edge will be displayed. In this example, the settings for the left edge
will be explained. Make adjustments as necessary when setting conditions for
the upper, lower, and right edges.
Binary
Measurement conditions
Left edge
Upper edge
Right edge
Lower edge
Reference registration
Judgement conditions
Fill profile
:
OFF
Binary tracking : OFF
End
Upper edge
Lower edge
Section 2-12
Measurement region
Right edge
2-12-(26)
Advertisement
Chapters
Table of Contents
