Edge Position Compensation - Omron F250-UME Software Manual

Edge Position Compensation

2-7 Edge Position Compensation
Operational Flow
1
page 2-7-(2)
Select the
measure-
ment image.
2
page 2-7-(3)
1
Set the
Set the
position
edge
compensa-
detection
tion region.
conditions.
3
page 2-7-(10)
Set the dis-
placement
direction.
4
page 2-7-(11)
Measure-
ment
screens
The Edge Position Compensation processing item is used to detect the
amount of measurement object displacement by using the edge of the mea-
surement region, where the density changes.
Position compensation is not possible if the measurement object is inclined.
The edge of the measurement region, where the density changes, is detected
and the position corrected.
2
Draw the
region.
(As required)
3 4
Re-register Set the
the judgement
reference conditions.
position.
Section 2-7
(As required)
5
Change the
detailed
conditions.
2-7-(1)