Pattern
2-20-3
Setting Detailed Conditions
The search settings can be changed here. Change the conditions if the mea-
surement results are unstable. Normally, these conditions can be left on the
default settings. After changing the settings, perform an object measurement
to check that measurement can still be performed correctly.
1.
Select Pattern.
ENT:Set SFT+ESC:Edit
A list of settings selections will be displayed.
1.Pattern
2.
Select Detailed conditions.
The Detailed Conditions Settings Screen will be displayed.
Detailed conditions
3.
Change the settings.
4.
Select End.
The settings will be registered and the screen in (1.) will return.
0.Scn 0=SET=
0.Camera image
1.Pattern
2.
Measurement conditions
Select region
Detailed conditions
Coordinate mode
Verification
:OFF
Candidate level
: [ 60]
End
Section 2-20
2-20-(12)