Omron F250-UME Software Manual page 371

EC Defect
CHECK
CHECK
The Measurement Conditions Settings Screen will be displayed.
Measurement conditions
2. Change the settings.
The settings will be registered and the screen in (1.) will return.
Outside Trimming
Select Outside trimming when there is a white-pixel area inside the in-
spected region that is not to be measured.
Input image
Inspected
region
Goal: To find the position
and area of this label
Filling Up Holes
Use the Filling up holes setting to specify how areas of black pixels con-
tained inside donut-shaped areas of white pixels are processed. If select-
ed, the black pixels will be processed as white pixels.
Input image
:
Area
:
[ 0.000 247808.000 ]
OFF
:
Outside trimming
OFF
:
Filling up holes
:
Sort
Area descending order
:
Label No. [ 0]
Simple
:
Defect display
End
Outside triming: ON
The area outside the inspected
region changes to white pixels.
(The whole input image area is used
for measurement.)
The position and the size of the middle label
will be found if the following conditions are set:
Sort conditions: Area, ascending order
Label number: 1
Hole filling: ON
Section 2-15
Measurement target
2-15-(38)